Assembly And Operation; Battery; Charging Method - Hitachi CJ 14DL Mode D'emploi

APPLICATIONS
Cutting various lumber and pocket cutting
Cutting mild steel plate, aluminum plate, and
copper plate
Cutting plastics, such as phenol resin and vinyl
chloride
Cutting thin and soft construction materials
Cutting stainless steel plate (With No. 97 blade)
REMOVAL AND INSTALLATION METHOD
OF BATTERY
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches (2 pcs.) on the sides of the
battery. (Fig. 3)
Handle
Insert
Pull out

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.

ASSEMBLY AND OPERATION

Push
Latch
Rechargeable

battery

Fig. 3
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged.
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
Charge status
lamp (red)
Overheat lamp (green)
3. Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE:
If the pilot lamp flickers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
English
Have it repaired
Battery
Fig. 4
11