Depressed Center Wheel Assembly And Disassembly - Hitachi G 10SR2 Mode D'emploi

English

DEPRESSED CENTER WHEEL ASSEMBLY AND DISASSEMBLY

WARNING:
1. Assembly
(1) Turn the disc grinder upsidedown so that the spindle is facing upward.
(2) Align the oval-shaped indentation of the wheel
washer with the notched part of the spindle,
then attach them.
(3) Fit the protuberance of the depressed center
wheel onto the wheel washer.
(4) Screw the wheel nut onto the spindle.
(5) While pushing the push button with one hand,
lock the spindle by turning the depressed center
wheel slowly with the other hand.
Tighten the wheel nut by using the supplied
wrench as shown in Fig. 5.
CAUTION: Tighten the wheel nut securely and
confirm that the depressed center
wheel does not wobble.
2. Disassembly
To remove the depressed center wheel, simply
reverse the above-mentioned procedure.
14
Never attempt to assemble or disassemble the depressed center wheel,
unless the power switch is in the "OFF" position and the electrical cord
has been disconnected from the receptacle.
Wrench
Depressed
Center
Wheel
Wheel
Washer
Spindle
Fig. 5
Wheel
Nut
Wheel
Guard
Push
Button