Installing/Removing Battery Pack; Assembly - Black & Decker LGC120 Mode D'emploi

6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
INSTALLING / REMOVING BATTERY PACK
WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure B).
TO REMOVE BATTERY PACK:
Depress the battery release button
in the back of the battery pack and
pull battery pack out of tool
(figure B).
B
AUXILIARY HANDLE ASSEMBLY (FIG. C)
• Position handle on upper tube to desired height.
• Ensure locking block (8) is aligned with groove in tube.
• Assemble and tighten bolt (9).
C
8
POLE EXTENSION (FIG. D)
• Loosen collar (10).
• Extend poles to desired length.
• Tighten collar.
8

ASSEMBLY

9
D
10