Adjusting Screen Position, Clock, And Phase (Automatic Adjust); Adjusting Screen Position, Clock, And Phase (Manual Adjust) - Pioneer Elite PRO-1010HD Mode D'emploi

Adjusting Screen POSITION, CLOCK,
and PHASE (Automatic Adjust)
During PC signal input, by pressing the AUTO SET UP
button on either remote control unit or the unit's
operating panel, the unit will automatically set the screen
position, clock and phase to best match the current image
input.
When the button is pressed, the optimum
settings are automatically selected for the
current input source.
AUTO SET UP
Display operating
Panel
Press the AUTO SET UP button on either the display
or remote control unit.
AUTO SET UP
Notes
÷ This setting is supported only when a computer signal is
connected to INPUT1 (D-sub) or INPUT5.
÷ Perform this adjustment individually for each input function
(INPUT1 (D-sub) or INPUT5), and each signal type.
÷ Optimum settings may not be possible for low-luminance and
certain other signals. In such cases, use the adjustment
methods explained on the this page, "Adjusting Screen
POSITION, CLOCK, and PHASE (Manual Adjust)".
÷ If you run AUTO SET UP , POSITION, CLOCK and PHASE are
automatically set even if you manually adjust them following
the procedures in the next section.
AUTO
SET UP
Remote control unit
Picture and Screen Adjustment
Adjusting Screen POSITION, CLOCK,
and PHASE (Manual Adjust)
Follow the procedure to save adjustment values for each
INPUT.
MENU
5/∞
2/3
SET
Display operating
panel
1
Press the MENU button to display the menu
screen.
STANDARD
PICTURE SCREEN
CONTRAST
BRIGHTNESS
H. ENHANCE
V. ENHANCE
PICTURE RESET
SET ENTER
2 Use the 2/3 buttons to select [SCREEN].
(MENU during PC signal input via INPUT1 or INPUT5.)
STANDARD
PICTURE SCREEN
POSITION
CLOCK
PHASE
SIZE
SCREEN RESET
ENTER
SET
MENU
2/3
SET
5/∞
Remote control unit
INPUT1
SETUP OPTION
:
0
:
0
:
0
:
0
MENU EXIT
INPUT1
SETUP OPTION
:
0 0
:
0
:
0
:
0 0
EXIT
MENU
39
EN