Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Violet/white
Blue
When the source is selected the tuner, a control signal is
output.
To Auto-antenna relay control terminal.
If the car features a glass antenna, connect to the antenna
booster power supply terminal (max. 300 mA 12 V DC).
Connection method
1.
Clamp the lead.
Note:
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the parking
brake switch.
Blue/white
When the source is switched ON, a control
signal is output.
To system control terminal of the power amp
(max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything
to the speaker leads that are not connected to speakers.
See the section "When connecting
with a back-up camera".
Power supply side
Ground side
2. Clamp firmly with
needle-nosed
pliers.
Parking brake
switch
Fig. 4
6
Publicité
Chapitres
Table des Matières
