Philips SWW1890 Mode D'emploi page 11

Establish the link between the
transmitter and receiver
‡ $ ÁDVKLQJ EOXH SRZHU /(' LV GLVSOD\HG
until the signal link between the two units
is established. Normally, it takes around
15-20 seconds for the link to establish
successfully.
‡ When you unplug the power cord of the
transmitter, the receiver enters standby
mode after 5 minutes.
» The power LED of the receiver lights
up in red.
‡ The link between the transmitter and
receiver re-established when you plug in
the power cord of the transmitter again.
» 7KH SRZHU /(' RI WKH UHFHLYHU ÁDVKHV
in blue.
LED indicator status of the
transmitter
Power LED indicator Status
Solid blue The link is established.
Flashing blue Linking is in progress.
LED indicator status of the receiver
Power Status Mode and status
LED LED
Solid Off Standby mode for power-
red saving
Flashing Flashing Setting up a Link between
blue the transmitter and
receiver
Solid Flashing On mode but without
blue quickly input from the computer/
source device
Solid Flashing On mode with
blue slowly unrecognized video format
Solid Solid On mode with recognized
blue blue video format
Note
‡
If the link is not established after 80 seconds, move
the transmitter, receiver and HDTV closer to each
other. The maximum transmission range is up to 20
feet without obstruction between the transmitter and
receiver.
‡
If more than one set of Philips Wireless HD Net
Connect is placed in the same room, make sure that
the minimum distance among each one is 6 feet.
‡
Make sure the computer is on and switched the signal
output to the HDMI.
‡
Make sure the video format is supported before the
video is displayed, see the chapter on Technical data for
information.
EN 11