LEGRAND Wattstopper EORS-101 Mode D'emploi page 4

To unpair the selected load(s)
• Tap the remote button 3 times to unpair the remote button from the switch.
• The load(s) will temporarily turn OFF and ON confirming the message was received.
• The green LED on the switch will stop flashing and exit pairing mode.
• The remote button should no longer control the load(s).
• Repeat steps above to unpair another button.
Press and hold the Wall Switch Pairing button "P" for about 10 seconds, until all LEDs on the units start flashing all together.
Does the system work more reliably at close range (without obstructions)?
In an indoor environment, the wireless controls have a typical range of 30-150 feet. If there are obstructions and/or noise interference
the range will be less than the typical range.
Consider Factors Affecting the Environment:
The range can be reduced by metal objects (metal decreases the effectiveness of RF transmission). Switches also go into a reduced
range mode when in programming (under 15 feet)
• Identify nearby metal, concrete and other objects possibly affecting signal strength
• If possible, try relocating the device (even slightly) away from obstructions to improve the system performance.
Consider Factors Affecting the Environment:
• Device placement
• Obstructions (metal, concrete, other construction materials)
• Interference
Does the system work better at certain times of the day?
• Look for pieces of equipment that may affect wireless performance when they are ON
• Noise interference can be either line noise (from motors) or Radio Frequency (RF)
Product Performance:
• To isolate any variation in product performance replace one piece of hardware at a time
Load does not turn ON or OFF:
• If load does not shut off automatically, enter configuration mode to check settings for the load (if in manual mode switch to auto
mode). If you cannot switch then sensor is not paired to load.
• If load does not turn on/off from remote switch, check pairing of the switch to the load. (See pairing devices.)
TO "UNPAIR" ALL CONNECTED DEVICES
TROUBLESHOOTING
4