Attaching The Brush Head - Philips Sonicare CleanCare 5000 Série Mode D'emploi

attaching the brush head

1 To place the brush head on the handle, slide
the ribs on the inside of the nut into the
grooves in the top of the handle.
2 Screw the brush head nut clockwise until it
is firmly tightened. If the brush head rattles
during use, tighten the nut further.
3 Remove the travel cap from the brush head
before you start brushing.
charging
Charge the Sonicare for at least 24 hours during the
first few days of use.
We advise you to keep the Sonicare in the plugged-
in charger when not in use, to maintain a full battery
charge.
When the battery is empty, it takes at least 24 hours
to charge the Sonicare fully.
1 Place the handle in the charger (with the on/off
button facing towards the front of the charger)
to charge the appliance.
Make sure the bottom of the handle sits back
securely in the charger so that it makes complete
contact.
, The charging light flashes slowly when the
handle is in the charger to indicate that charging
is in progress.
, When the Sonicare is fully charged, the charging
light lights up continuously to indicate that the
Sonicare is ready for use.
EnglisH
7