Pioneer PDK-5014 Mode D'emploi page 14

2
Attaching bracket bolts to display stand
Display
stand
3
Attaching bracket to plasma display
Hexagonal bored bolts
(M8 x 20)
14
En
Attach the hexagonal bored bolts (M8 x 20) to the display
stand as the figure, being sure to leave a space of 5 to 6
millimeters when doing so. (Note that these bolts may be
attached at two different levels to allow a distance of 1350
mm or 1170 mm from the floor to the center of the display
panel.)
Note: The bracket bolts may not be screwed into the third
set of screw holes from the top, as these screw
holes are used in Step 4 below.
Hexagonal bored
bolts (M8 x 20)
Using the hexagonal bored bolts (M8 x 20), attach the
bracket to the rear of the plasma display by screwing the
bolts into the screw holes as the figure.
Note 1: The plasma display should be placed on a blanket
or other soft surface so as to avoid scratching or
otherwise damaging the surface of the display.
Note 2: In order to ensure safe installation, always be sure
to alternately tighten each bolt two times or more
until they are firmly fixed in place.
Bracket
5 to 6 mm
Plasma display
How to install