Makita 3706 Manuel D'instruction page 5

CAUTION:
Before plugging in the tool, always check to see
•
that the switch lever actuates properly and returns
to the ''OFF'' position.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, move the switch lever to the ''ON''
position.
To stop the tool, move the switch lever to the ''OFF''
position.
This can be done in the forward area of the switch lever
or by bumping off the rear area of the switch lever.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing bit
1
5
2
6
3
004968
CAUTION:
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
When using the bit with 6.35 mm (1/4") shank
•
diameter, first replace the collet cone 3.18 mm
(1/8") with the collet cone 6.35 mm (1/4"), then
install the bit.
To install the bit, insert the bit all the way into the collet
cone.
Press the shaft lock to keep the shaft stationary and use
the wrench to tighten the collet nut securely.
To remove the bit, follow the installation procedure in
reverse.
1. Bit
2. Collet nut
3. Shaft lock
4. Wrench
5. Loosen
6. Tighten
4
Changing the collet cone
1 2
2
004969
CAUTION:
Use the correct size collet cone for the bit which
•
you intended to use.
Do not tighten the collet nut without inserting a bit,
•
or the collet cone will break.
To change the collet cone, loosen the collet nut and
remove. Remove installed collet cone and replace with
desired collet cone. Reinstall collet nut.
OPERATION
004970
CAUTION:
Avoid forcing the bit to bend or twist. It may snap.
•
Before turning the tool on, make sure the bit and
•
collet nut are securely tightened.
Hold the tool secure with the bit pointing in a safe
direction not contacting any surface and slide the switch
to the ''ON'' position. Wait until the tool attains full speed.
When starting the multipurpose bit into the material, hold
the tool at approximately a 45 degree angle with the edge
of the shoe base contacting the material.
Carefully bring the tool to a straight position so the shoe
base is in full contact with the material.
004971
5
1. Collet nut
2. Collet cone