Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
obstructing the image. An optional cable management system is available from Epson
(part # ELPCK01).
9.
Attach the cable cover to the projector
Take up the cable slack, and then attach the cable cover and use a cross-head screwdriver to tighten
the screws (2) and secure the cable cover.
Cable cover
10. Turn on the projector and check the image
1.
Plug in and turn on the projector.
2.
Hold down the A/V Mute button on the remote control for five seconds to flip the image
top-to-bottom.
3.
Loosen the screws on the adjustment unit (A, B, C, and D) as shown below to adjust the image
position.
4.
Adjust the vertical angle of the arm using screw (E) on the bottom of the arm plate. The arm rises
when you tighten the screw, and lowers when you loosen it.
A: Vertical tilt adjustment: -7 to 17° (arm length minimum)
: -17 to 7° (arm length maximum)
B: Horizontal roll adjustment: 0 to ± 5°
C: Horizontal rotation adjustment: 0 to ± 5°
D: Horizontal slide adjustment:
0 to ± 1.8 inches (0 to ± 45 mm)
E: Vertical angle adjustment screw:
0 to 5.3 inches (0 to 134 mm) (arm length minimum)
0 to 9.1 inches (0 to 230 mm) (arm length maximum)
Adjustment unit
28
Arm plate
Publicité
Table des Matières
