Velleman DVM171THD Mode D'emploi page 3

6. Follow the instructions on your screen.
7. After the installation, connect the DVM171THD to a USB port of the PC.
8. Go to [Device Manager] via [Start] => [Control Panel].
You should see a yellow question mark and an unknown device in the list.
9. Right-click the unknown device and select [Properties].
10. Now, open the [Drivers] tab (driver).
11. Click on [Update Driver Software...].
nd
12. Select the 2
13. Browse to the folder [Drivers] on the CD-ROM.
14. Click on [OK].
15. Click on [Allow the installation procedure to start].
The drivers are installed and the device is ready to be used.
5. Use
1. First, install the data logger software on a personal computer, by inserting the
enclosed disc into the CD drive and following the instructions on the screen.
2. Remove the protective cover [1] from the data logger, plug the data logger
into a free USB slot on the personal computer and start the data logger
software.
3. Set up the data logger software and press the Setup button. Refer to the help
function of the data logger software (Help > Help topics...) for more
information on the use of the software and setup of the data logger.
V. 05 – 19/09/2017
option [Search for Drivers on my Computer].
DVM171THD
1. protective cover
2. USB connector to PC port
3. start button
4. RH and temperature sensors
5. alarm LED (red/yellow)
6. recording LED (green)
7. mounting bracket
3 ©Velleman nv