Audio Language; Subtitle Language; Digital Output; Dts - Samsung DVD-V4600 Mode D'emploi

Audio Language

To set the Audio Language to your preferred language,
follow these steps. If your preferred language is
available on a DVD, your Audio Language will
automatically be set to the language you choose.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD" then
press the ENTER button.
3 Select "Language"
Move the selection bar to "Language" then press
ENTER to select.
4 Select "Audio"
Highlight "Audio," then press the ENTER button.
5 Set "Audio Language" Preference
Highlight your preferred language for audio
soundtracks, then press the ENTER button.

Subtitle Language

To set the Subtitle Language to your preferred language,
follow these steps. If your preferred language is
available on a DVD, your Subtitle Language will
automatically be set to the language you choose.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Language"
Move the selection bar to "Language" then press
ENTER to select.
4 Select "Subtitle"
Highlight "Subtitle", then press the ENTER button.
5 Set "Subtitle Language" Preference
Highlight your preferred language for subtitles, then
press the ENTER button.
Subtitle Language
Automatic
Subtitle
ENG-16

Digital Output

If your A/V receiver is equipped with a Dolby Digital
decoder, your DVD-VCR can output Dolby Digital 5.1
sound, but you MUST enable this feature in the menu
system to prevent damage to your speakers.
NOTE: Select "Bitstream" ONLY if you have connected
a Dolby Digital-equipped A/V receiver to the
Digital Output (coaxial) on the DVD-VCR rear
panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "Digital Output"
Highlight "Digital Output" then press the RIGHT
button to select one of the following options:
• PCM – To use your DVD/TV with an A/V
receiver without a Dolby Digital
decoder.
• Bitstream –To use your DVD/TV with an A/V
receiver with a Dolby Digital decoder.
PCM
Bitstream
PCM Down Sampling : On

DTS

If your A/V receiver is equipped with a DTS decoder,
your DVD-VCR can output DTS digital sound, but you
MUST enable this feature in the menu system.
NOTE: Select "On" ONLY if you have connected a
DTS-equipped A/V receiver to the Digital audio
Out (coaxial) on the DVD-VCR rear panel.
1 Open "MENU"
Press the MENU button while the DVD is in Stop
mode.
2 Select "DVD"
Use the UP/DOWN buttons to highlight "DVD"
then press the ENTER button.
3 Select "Audio"
Highlight "Audio", then press the ENTER button.
4 Set "DTS"
Highlight "DTS" then press the RIGHT button to
select one of the following options:
• Off – To use your DVD/TV with an A/V receiver
NOT equipped with a DTS decoder.
• On – To use your DVD/TV with an A/V receiver
equipped with a DTS decoder
Off
On
PCM Down Sampling : On
ENG-17