Deactivating The Demonstration; Inserting Batteries; Carrying The System - Sony MHC-V11 Mode D'emploi

• Avoid the following kinds of locations.
Between buildings
Nearby mobile phones,
electrical appliances
On steel desks or tables
• Keep the antenna away from the AC
power cord and the USB cable to avoid
picking up noise.
 Power
Connect the AC power cord (supplied)
to the system, and then to the wall
outlet.
When the AC power cord is connected,
the demonstration (page 14) starts
automatically. If you press  to turn
on the system, the demonstration
ends.
Deactivating the
demonstration
To deactivate the demonstration
while the system is turned off, press
SPEAKER LIGHT repeatedly to select
Standby Mode (page 14).

Inserting batteries

Insert two R03 (size AAA) batteries
(supplied), matching the polarities
shown below.
Notes
• Do not mix an old battery with a new one
or mix different types of batteries.
• If you do not use the remote control for a
long period of time, remove the batteries
to avoid damage from battery leakage
and corrosion.

Carrying the system

Before carrying the system, make
sure that there is no disc loaded and
no USB device is connected, and
disconnect all the cords.
Note
Correct hand placement while carrying the
system is very important to avoid personal
injury and/or property damage.
13
GB