Device Description; Initial Use - Beurer TL 100 Mode D'emploi

• Do not use the device in the presence of flammable anaesthetic gas connections with air, oxygen or nitro-
gen oxide.
• No calibration and no preventive checks or maintenance are to be carried out on this device.
• You cannot repair the device. The device contains no parts that you can repair.
• Do not make any changes to the device without the manufacturer's permission.
• If the device has been changed, thorough tests and checks must be carried out to ensure the continued
safety of further use of the device.
• Do not position the device in a location where it is difficult to disconnect it from the mains supply.
• Check the device before each use. Do not use the device if it is damaged in any way. The continuous use
of a damaged unit can be dangerous and may cause injury or improper results.
• The main material of the case is made of PC/ABS. Be cautious of potential allergic reactions to these
materials.
General notes
Important
• Always consult a doctor before using the daylight therapy lamp if you are taking medication such as pain
relief medication, medication to reduce high blood pressure or antidepressant medication.
• Diabetics and people who suffer from retinal diseases must be examined by an optician before using the
daylight therapy lamp.
• Please do not use the daylight therapy lamp if you suffer from an eye disease such as cataracts, glauco-
ma, diseases of the optic nerve or inflammation of the vitreous body.
• If you have health concerns of any kind, consult your GP!
• Remove all packaging material before using the device.
• Light sources are excluded from the guarantee.
Repairs
Important
• Do not open the device. Do not attempt to repair the device yourself. This can result in serious injury. Fail-
ure to comply will result in voiding of the warranty.
• For repairs, please contact Customer Services or an authorised retailer.

4. Device description

Overview
1. Fluorescent screen
2. Timer adjustment
3. Timer LED display
®
4. LED for Bluetooth
5. Brightness adjustment (dimmer)
6. On/off button
7. Mains part connection
System requirements:
– iOS ≥ 8.0, Android™ ≥ 4.4
– Bluetooth ® ≥ 4.0

5. Initial use

Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any damage or
faults on the device, do not use it and contact customer services or your supplier.
Positioning the device
Place the device on an even surface. The position should be chosen to ensure a distance of between 10 cm and
40 cm between the user and the device. The lamp is most effective at this distance. Ensure that there is a mains
socket close to the set-up area. Arrange the mains cable so that no-one will trip over it.
1
2 3 4
12
6
5
7