Oase Vitronic 18 Notice D'emploi page 6

- English -
Installation and connection
Prerequisite
• The unit head is removed. (→ Removing the unit head)
Set-up the unit
How to proceed: 1.
0.
B, C
• Install the unit at least 6.6 ft (2 m) from the edge of the pond.
• Only install the unit in the permitted positions to ensure fault-free operation.
• Allow sufficient space for carrying out maintenance work.
Connect the unit
Use hoses that are suitable for a pressure of at least 14.5 psi (1 bar).
How to proceed: 1.
0.
D
1. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
− This reduces pressure losses.
2. Connect the hose with the stepped hose adapter and secure with a hose clip.
− In the case of a stepped hose adapter with separate union nut, first push the union nut over the hose.
3. Connect the stepped hose adapter with seal to the casing.
− Connect the inlet and outlet.
− Hand tighten the stepped hose adapter.
Connect the unit to the flow-through filter.
The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to the inlet nozzles on the
flow-through filter. Adhere to the instructions for use of the flow-through filter.
4. How to proceed:
0.
E
1. Unscrew the cover cap.
2. Guide the outlet sockets with flat seal through both holes in the container wall of the flow-through filter.
3. Screw the inlet nozzle with O ring onto the outlet socket and hand tighten.
4. Connect the supply hose to the inlet socket. (→ Establish connections)
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Prior to reaching into the water, switch off the mains voltage to all units used in the water.
• Switch off the mains voltage prior to carrying out work on the unit.
Prerequisite
• Switch the pump on first, then switch on the UVC clarifying unit.
• Check all connections for leaks.
Switching ON/switching OFF
• Switching on: Insert the power plug into the socket.
− The unit switches on immediately.
• Switching off: Disconnect the power plug.
Check the function.
F
• The function display is lit when the UVC lamp is switched on.
• The transparent stepped hose adapters are lit when the UVC lamp is switched on.
6
23929-11-13_GA_Vitronic 18_USA.p6 6 19.11.2013 11:58:29