Aventics VS CL03 Mode D'emploi page 80

80 AVENTICS | CL03/CL03-XL | R402000141–BDL–001–AE
Assembly
Risk of too high total current
The VS is supplied with 24 V DC supply voltage with electrical
isolation via a power supply unit according to DIN EN 60742,
classification VDE 0551.
O
When wiring, ensure that at least 2 GND pins are
connected to ensure that the total current from all valve
solenoids can be absorbed (20 mA per solenoid). All GND
pins in the multipole plug are bridged. This must be
observed in particular with a CL03-XL subbase with dual
signal.
O
Protect the solenoid control with an external fuse.
O
Do not exceed the permissible current load of 1 A per
connnection pin!
C B A
Fig. 9: Connector pin allocation for up to 16 valves/32 solenoids (A)
and for up to 18 valves/32 solenoids (B)
CAUTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16