Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
The fireplace control functions can be accessed in two (2) ways:
1. Using the touchpad control panel, located in the upper right-hand corner of the fireplace.
2. Using the multifunction remote control.
The fireplace features conveniently separate controls for flame effect and for heater control. This allows you to
operate the unit in two (2) different modes:
1.
As a full-featured fireplace - both flame effect and heater are on.This mode allows you to enjoy the look of
the fire along with the heat output of a heater.
2.
As a visual effect - only the flame effect is on, the heater is off. We recommend this mode for warm weather
application, when you want the ambiance of a fire, without any heat output.
REMOTE CONTROL INFORMATION
The infrared remote control relies on a line of sight and must be pointed at
the flame/screen of the fireplace to work. The remote control unit has the
controls required to turn ON/OFF both the main power and the heater. If
you prefer, use the touchpad control on the fireplace unit itself.The layout
of the buttons on touchpads and remote control unit can be seen in
Figures 3 and 4, respectively.
1. Plug your fireplace into a 15-amp, 120-volt power outlet.
2. Turn the power on. Flame will show on the back screen of the
fireplace.
3. Remove plastic tab from inside battery compartment to activate
remote control.
4. Point the remote control directly at the fireplace flame/screen and
use the buttons to operate the fireplace.
9
8
Figure 3.
1. MAIN POWER BUTTON
This button supplies power to all the functions of the fireplace. The Main Power button must be in the ON
position, either from the remote or on the touch pad for the functions to work.
2. FLAME BRIGHTNESS CONTROL
This button controls the brightness of the flame effect with settings at High(C3), Medium(C2), and
Low(C1). When first turned on, the flame will come on at the highest setting. The log set will remember
the last flame setting used, unless power to the unit has been interrupted. Each time the flame button is
pressed, the flame brightness increases. The only way to turn off the flame effect completely is to turn off
the main power button.
3. HEATER BUTTON
Heater on / off. There are 2 operation modes:
OFF is to turn off the heater. ON is to turn on the heater.
8
7
6
5
4
3
2
1
The plastic tab inside the battery
compartment MUST be removed
before the remote control will operate.
(Pull Tab)
Figure 4.
2
6
7
1
4
3
5
Publicité
Chapitres
Table des Matières
Dépannage
