Cycle Descriptions - Hamilton Beach Commercial Summit Série Mode D'emploi

840076600newENv02 3/7/02 8:33 AM Page 10
Operating the Blender
Program Cycles

Cycle Descriptions

The Cycle buttons on the Control Panel
allow you to select the program cycles
described below:
Each cycle's speed fluctuates in a prepro-
grammed combination of pulses to blend
a specific type of drink. See the charts
below and the diagrams on page 11 for
detailed descriptions.
Pre-Programmed Blending Profiles
Profile Button
0
1
2
3
4
5
Additional Blending Profiles (Optional--see Programming Section, page 9)
Profile Button
6 --
7 --
8 --
9 --
NOTE: You may wish to experiment with each cycle to determine the most effective blending
cycle for commonly-made drinks. You may vary the time for each profile based on the size of
the batch/drink you are most commonly blending.
For instructions on programming the cycle buttons, see page 9.
10
Time Suggested Applications
30 Sec. For smoothies with IQF fruit.
25 Sec. For smoothies with dairy products
and milkshake blends.
23 Sec. For smoothie concentrated mixes, margaritas,
daiquiris, and iced cappuccinos
15 Sec. For thin consistency drinks.
26 Sec. For thick specialty drinks.
60 Sec. For soups, salad dressings, sauces, and dips.
Time Suggested Applications
25 Sec. For controlled blending of ingredients.
20 Sec. For small batches of thin consistency drinks.
20 Sec. For quick, homogenized blending.
30 Sec. For general blending.
To end a cycle, press either STOP or
any cycle button. DO NOT remove the
container while the unit is running.
You cannot change cycles while the unit
is running by selecting a new cycle on
the Control Panel.
10