Safety Information; Basic Safety Information; Prerequisites; Operating - Dentsply Sirona inLab MC X5 Notice D'utilisation

2 Safety information

2.1 Basic safety information

8
2
Safety information
Basic safety information
2.1
2.1.1

Prerequisites

NOTE
Important information on building installation
The building installation must be performed by a qualified expert in
compliance with the national regulations. DIN VDE 0100-710 applies
in Germany.
NOTE
Restrictions regarding installation site
The system is not intended for operation in areas subject to explosion
hazards.
NOTE
Do not damage the unit!
The unit can be damaged if opened improperly.
It is expressly prohibited to open the unit with tools!
2.1.2

Operating

The suction system must only be operated with an integrated filter bag
and HEPA filter. Only the approved filter bags and HEPA filters may be
used (see "Spare parts and consumables [→ 26]").
CAUTION
Dry processing
Before using dry processing, verify the functioning, correct connection
and the tightness of the connections. All available suction openings
must be available.
CAUTION
Dry processing
Before dry processing, check that the CEREC suction device contains
a functioning HEPA fine-dust filter.
2.1.3

Maintenance and repair

As manufacturers of dental instruments and laboratory equipment, we
can assume responsibility for the safety properties of the unit only if the
following points are observed:
● The maintenance and repair of this unit may be performed only by
Dentsply Sirona or by agencies authorized by Dentsply Sirona.
● Components which have failed and influence the safety of the unit
must be replaced with original (OEM) spare parts.
● Only original cables may be used, so that EMC requirements are
met.
Dentsply Sirona
Operating Instructions for suction devices
64 98 609 D3608
D3608.201.02.05.02 10.2020