Trouble Shooting - Gaggenau CM 210 Notice D'utilisation Et D'entretien

Trouble shooting

Malfunction
ADD 8EanS
displayed despite a full
bean container.
No hot water or steam
discharge.
Froth insufficient or too
runny.
Coffee is running a drop at
a time.
Coffee has no "crema"
(layer or froth).
Grinding unit is not grinding
coffee beans.
Descaling program does
not start.
Cleaning program does
not start.
Cause
is Grinder has still not been
filled automatically.
The beans are too big or too
oily – they do not slide into
the grinding unit.
Nozzle is blocked.
Sleeve a on nozzle 12 not in
correct position.
Unsuitable milk.
Degree of grinding too fine.
The beans are too oily.
Preground coffee too fine.
Unsuitable type of coffee.
Beans no longer fresh.
Degree of grinding not
appropriate for coffee beans.
Beans are not falling into the
grinding unit (too oily).
Current programming set to
filter yes/new
change filter
display.
System too hot.
System too hot.
filter change
displayed.
Remedial action
Press the n
Use less oily or smaller beans.
To remove big beans use
a vacuum cleaner.
Thoroughly clean nozzle.
Push down sleeve a on
nozzle 12.
Use cold semi-skimmed milk.
Select a coarser degree of
grinding.
Use less oily beans.
Use a coarser ground coffee.
To rinse the appliance, follow
the instructions "Using ground
coffee" on page 16, but do not
add coffee powder in the duct.
Change the type of coffee.
Use fresh beans.
Optimize degree of grinding.
Gently tap the bean container.
Set programming to
or filter no/old
Before descaling the appliance,
always remove the filter!
Draw off some of the hot water.
Draw off some of the hot water.
Change filter.
buton.
.
33