Indoor Unit; Outdoor Unit; Preparation Before Operation - Mitsubishi Electric MSZ-EF18VGW Notice D'utilisation

D
ISPOSAL
To dispose of this product, consult your dealer.
Note:
This symbol mark is for EU countries only.
This symbol mark is according to the directive 2012/19/
EU Article 14 Information for users and Annex IX, and/
or to the directive 2006/66/EC Article 20 Information for
end-users and Annex II.
Fig. 1
N
AME OF EACH PART

Indoor unit

Front panel
Air fi lter
(Air purifying fi lter)
Air cleaning fi lter
(Silver-ionized air purifi er
fi lter)
Air inlet
Horizontal vane
Air outlet
Heat exchanger
Spec name plate *1
Operation
indicator lamp
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
Emergency
operation
switch *2
Remote control
receiving section
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
Your MITSUBISHI ELECTRIC product is designed and manufactured with high
quality materials and components which can be recycled and/or reused.
This symbol means that electrical and electronic equipment, batteries and
accumulators, at their end-of-life, should be disposed of separately from your
household waste.
If a chemical symbol is printed beneath the symbol (Fig. 1), this chemical sym-
bol means that the battery or accumulator contains a heavy metal at a certain
concentration. This will be indicated as follows:
Hg: mercury (0.0005%), Cd: cadmium (0.002%), Pb: lead (0.004%)
In the European Union there are separate collection systems for used electrical
and electronic products, batteries and accumulators.
Please, dispose of this equipment, batteries and accumulators correctly at your
local community waste collection/recycling centre.
Please, help us to conserve the environment we live in!

Outdoor unit

Outdoor units may be different in appearance.
*1 The manufacturing year and month are indicated on
the spec name plate.
When the remote controller cannot be used...
*2
Emergency operation can be activated by pressing the emergency operation switch
(E.O. SW) on the indoor unit.
Each time the E.O. SW is pressed, the operation changes in the following order:
Emergency Emergency
COOL HEAT Stop
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
Air inlet (back and side)
Spec name plate *1
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
: Lit
: Not lit
Set temperature : 24°C
Fan speed : Medium
Horizontal vane : Auto
3.
Press the DAY button
to set the day.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Each press increases/decreas-
es the time by 1 minute (10
minutes when pressed longer).
EN-3
EN