Cleaning And Care; Cleaning The Dust Container; Cleaning The Suction Opening; Maintenance - Micromaxx MD 16322 Mode D'emploi

9. Cleaning and care

Empty the dust container and clean the filter and cyclone insert ideally after every
use. Clean the suction opening as required.
• Do not use solvents or caustic/gaseous cleaning agents to clean the surfaces of
the appliance and the accessories. Wipe the surface with a damp cloth.

9.1. Cleaning the dust container

We recommend emptying the dust container and cleaning the filter after every use.
Carry out the following steps:
The appliance is switched off.
 Press the unlocking button above the handle.
 Remove the dust container from the motor block.
 Remove the dust filter by pulling on the ribbed flap.
 Remove the cyclone insert by taking hold of it inside the opening and pulling it
out.
 Empty the dust container over a dustbin.
 Rinse the dust container and the cyclone filter with water and clean the dust fil-
ter regularly under running water. Rinsing is not necessary every time. Never put
the dust container in the dishwasher!
 When the dust container, cyclone insert and filter are dry again, fit the filter
housing and the cyclone insert with the dust filter into the dust container so that
the seal on the filter closes off the dust container.
 Place the dust container onto the motor block by firstly inserting it into the
catch at the bottom of the motor block and then folding it shut until the unlock-
ing button clicks audibly into place.
CAUTION!
Before using the appliance for the first time, please ensure that the dust
filter in the dust container has been inserted correctly. If this is not the
case, it can lead to the vacuum cleaner being damaged.

9.2. Cleaning the suction opening

After a while, dirt and dust can collect around the suction opening and can reduce
the suction power. To avoid this, the suction opening should be cleaned regularly.
 Switch off the appliance.
 Remove dirt and dust from around and inside the suction opening.

10. Maintenance

10.1. Replacing the fuse in the car charger adapter

 Pull the car charger adapter BE24L-030-096 out of the
12 V socket in your car.
80 of 88