Using The Vacuum Cleaner - Micromaxx MD 16322 Mode D'emploi

BE24L-030-096 to the 12 V
The appliance will charge; the operating light flashes red. Once the battery is
charged, the operating light will light up green.
 After charging, remove the plug on the mains adapter from the mains socket
or the car charger adapter from the socket in the car and remove the jack plug
from the appliance.
NOTE!
Charge the battery for at least 24 hours before using the vacuum clean-
er for the first time.
Always charge the battery when the suction power drops significantly
and the operating light flashes green.
7.1.1. Charging in the wall mount
If you want to charge the vacuum cleaner in the wall mount, proceed as follows:
Install the wall mount and the mains cable as described above.
 Connect the mains adapter to a mains socket for charging the battery.
 Hold the vacuum cleaner by the handle and insert it into the wall mount with
the dust container facing upwards.
When the operating light flashes red, the vacuum cleaner is correctly mounted and
the battery is being charged. Once the battery is charged, the operating light will
flash green.
 After charging or when the appliance is not in use, pull the plug on the mains
adapter out of the mains socket again.

8. Using the vacuum cleaner

 Ensure that the filter housing and the dust filter are precisely fitted in the dust
container and that the dust container has been securely mounted on the motor
block.
 Connect a suitable suction nozzle:
− The crevice nozzle for vacuuming difficult-to-reach areas.
− The nozzle for liquids for vacuuming up small amounts of liquid (e.g. spilt
drinks or similar).
 Switch on the vacuum cleaner by setting the On/Off switch to position I .
NOTE!
For reasons of hygiene, clean the dust container and the filter immedi-
ately after you have vacuumed up liquids. Allow the parts to dry com-
pletely before using the appliance again.
 Switch off the vacuum cleaner by setting the On/Off switch to position 0.
socket in your car.
DE
FR
NL
EN
79 of 88