Makita DFS250 Manuel D'instruction page 8

2
Fig.12
► 1. Locator 2. Driver bit 3. Magnetic bit holder
To remove the driver bit, pull the locator, and then grasp
the bit with a pair of pliers and pull the bit out of the
magnetic bit holder. To install the driver bit, push it firmly
into the magnetic bit holder. Then install the locator by
pushing it firmly back.
For DFS251
1
Fig.13
► 1. Locator
Fig.14
► 1. Locator 2. Socket bit
To remove the socket bit, pull the locator, and then pull
the socket bit. To install the socket bit, push it firmly into
the sleeve. Then install the locator by pushing it firmly
back.
1
3
1
2
Hook
1
2
3
Fig.15
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
Screwdriving operation
Fig.16
Fit the screw on the point of the bit and place the point
of the screw on the surface of the workpiece to be fas-
tened. Apply pressure to the tool and start it. Withdraw
the tool as soon as the clutch cuts in. Then release the
switch trigger.
CAUTION:
When fitting the screw onto the point
of the bit, be careful not to push in on the screw. If
the screw is pushed in, the clutch will engage and
the screw will rotate suddenly. This could damage a
workpiece or cause an injury.
CAUTION:
Make sure that the bit is inserted
straight in the screw head, or the screw and/or bit
may be damaged.
8 ENGLISH
1
2
3