Moving Your Appliance; Storing Food In The Fridge; Vacation Time - Domo DO938K Mode D'emploi

· In the 0 position the appliance does not operate (the cooling system is switched off), but power supply
is not interrupted.
· The running time and temperature are affected by where the fridge is located, how often the door is
opened and the temperature of the room the fridge is located in.

MOVING YOUR APPLIANCE

· If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will
allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes before turning on.
· Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation
to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the
room where the appliance is located for a few minutes.

STORING FOOD IN THE FRIDGE

The fridge helps to extend the storage times of fresh perishable foods.
Fresh food care for best results:
· Store foods that are very fresh and of good quality.
· Ensure that food is well wrapped or covered before it is stored. This will prevent food from
dehydrating, deteriorating in colour or losing taste and will help maintain freshness. It will also prevent
odour transfer.
· Make sure that strong smelling foods are wrapped or covered and stored away from foods such as
butter, milk and cream which can be tainted by strong odours.
· Cool hot foods down before placing them in the fridge.
DEFROSTING
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or hoarfrost form at the back of the refrigerator. This
is normal. It is not necessary to wipe off the condensation or frost. The rear panel defrosts automatically.
The condensation runs into the condensation channel and is conveyed to the cooling from where it
evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can run out.

VACATION TIME

For short vacation periods, leave the control knobs at their usual settings. During longer absences:
· Remove all foods.
· Disconnect from electrical outlet.
www.domo-elektro.be
37
DO938K