Oil Level Check; Oil Change; Reduction Case Oil; Recommended Oil - Honda GX240 Manuel De L'utilisateur

Oil Level Check

Check the engine oil level with the engine stopped and in a level
position.
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert the oil filler cap/dipstick into the oil filler neck as shown,
but do not screw it in, then remove it to check the oil level.
3. If the oil level is near or below the lower limit mark on the
dipstick, fill with the recommended oil (see page
upper limit mark (bottom edge of the oil fill hole). Do not overfill.
4. Reinstall the oil filler cap/dipstick.
OIL FILLER CAP/DIPSTICK
OIL FILL HOLE
(bottom edge)
Running the engine with a low oil level can cause engine damage.
This type of damage is not covered by the Distributor's Limited
Warranty.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below the safe limit. However, to
avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.

Oil Change

Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, oil drain plug and washer.
2. Allow the used oil to drain completely, then reinstall the oil drain
plug and new washer, and tighten the oil drain plug securely.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.
3. With the engine in a level position, fill with the recommended oil
(see page ) to the upper limit mark (bottom edge of the oil fill 8
hole) on the dipstick.
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered by the Distributor's
Limited Warranty.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below the safe limit.
However, to avoid the inconvenience of an unexpected
shutdown, fill to the upper limit, and check the oil level regularly.
4. Install the oil filler cap/dipstick and tighten securely.
8 ) to the
REDUCTION CASE OIL (applicable types)
UPPER LIMIT

Recommended Oil

Use the same oil that is recommended for the engine (see page ).
Oil Level Check
Check the reduction case oil level with the engine stopped and in a
level position.
2 : 1 Reduction Case With Centrifugal Clutch
LOWER LIMIT
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert and remove the oil filler cap/dipstick without screwing it
into the filler hole. Check the oil level shown on the oil filler cap/
dipstick.
3. If the oil level is low, add the recommended oil to reach the
upper limit mark on the dipstick.
4. Screw in the oil filler cap/dipstick and tighten securely.
UPPER LIMIT
ENGLISH
OIL FILLER CAP/
DIPSTICK
WASHER
OIL LEVEL
DRAIN PLUG
LOWER LIMIT
8
OIL FILLER CAP/DIPSTICK
9