Installation Procedure - Toto LT645 Manuel D'installation Et D'utilisation

1) Install the faucets and drain fittings (not included) per the manufacturer's
instructions�
2) Insert the tie hooks and packings into the the mounting holes at the
bottom of the lavatory (see Ill� 1)�
3) Place the lavatory onto the countertop while carefully aligning the tie
hooks with the holes in the countertop�
4) Check to make sure the back wall of the lavatory is flush with the wall;
adjust if necessary�
5) Place the washers onto the tie hooks and install the wing nuts (see Ill� 2)�
6) Make sure the tie hooks are oriented properly in the lavatory (see Ill� 3)�
7) Tighten all wing nuts until the lavatory is firmly held in position�
DO NOT OVERTIGHTEN� Overtightening may damage the products
and cause personal injury and/or property damage�
WARNING
Ill. 1
Tie Hook
Packing
1) Using the supplied tube caulking, run a bead of caulk around the sides
of the lavatory�
2) Continue by applying caulk to the back wall and top of the lavatory�
3) Wipe away any excess sealant and fill voids as necessary� Allow sealant
to set for approximately 30 minutes�

INSTALLATION PROCEDURE

Ill. 2
Washer
Wing Nut
Final Caulking
4
Ill. 3
Counter Table
TIE HOOK
TIE HOOK ORIENTATION DIAGRAM