Display Hold Mode - OHAUS NAVIGATOR XT NVT1601/1 Manuel D'instructions

®
Navigator

3.4 Display Hold Mode

This mode holds the highest stable weight value for easy reference.
1. Press and hold Mode until [Hold] is displayed.
2. Place samples to be weighed on the pan. When the balance detects the highest stable weight
the "Hold Indicator" will blink and the displayed weight will not change.
3. Press Function to release the held weight value.
3.5 Accumulation Mode
This mode allows the user to store the total of a series of weight measurements. With an Interface
Option the component weights and the total weight can be transmitted.
1. Press and hold Mode until [ACCUmM] (Accumulate) is displayed. [Clr.Acc] (clear accumulate)
will then display.
2. Press Yes to clear the stored value or No to continue adding to the stored total.
3. If required, place an empty container on the pan and press Tare.
4. Add first item, its weight is displayed. Press Function to store the weight, the "Accum" indicator
will flash and the display will show the total weight.
5. Remove the first item and add the next item. The balance will display its weight. Press
Function to store its weight. The "Accum" indicator will flash and the new total weight will be
displayed.
6. Repeat step 5 for all of the items to be added. Note: While the display indicates zero, press
Function to view the current total number of samples and the total weight.
7. To clear the stored total press and hold Mode until [ACCUmM] is displayed. Press Yes when
[Clr.Acc] is displayed.
3.6 Checkweigh Mode
This mode sets low and high weight limits for portion control processes.
1. Press and hold Mode until [CHeCk] (Check) is displayed. [CLr.ref] (clear references) will then
display.
2. Press No to use the stored reference weight limits and proceed to step 5.
Note: Press Function to view the low and high reference weight limits.
3. Press Yes to establish new reference values. The balance will then display [Set. Lo]. Press
Yes to view the "Low" limit value. Press Yes to accept or No to edit the "Low" limit value. The
stored value then displays with the first digit highlighted [000.000 kg]. Repeatedly press No
until the desired number appears. Press Yes to accept and highlight the next digit. Repeat until
all the digits are correct. Press Yes to accept the "low" limit value, [Set. Hi] will be displayed.
4. Repeat the same procedure to accept or edit the "high" value.
5. Place sample material on the Pan. The "Accept" indicator will now show that the sample weight
is within the acceptable range.
6. To clear the stored reference values press and hold Mode until [CHeCk] is displayed. Press Yes
when [Clr.ref] is displayed.
EN-5