Remaining Hazards; Machine Specifications; Machine Description - Powermatic PM1500 Mode D'emploi

Keep children and visitors a safe distance from the work area.
Never leave a running machine unattended. Before you leave the
workplace switch off the machine.
Do not operate the electric tool near inflammable liquids or gases.
Observe the fire fighting and fire alert options, for example the fire
extinguisher operation and place.
Do not use the machine in a dump environment and do not expose
it to rain.
Wood dust is explosive and can also represent a risk to health.
Dust form some tropical woods in particular, and from hardwoods
like beach and oak, is classified as a carcinogenic substance.
Always use a suitable dust extraction device
Before machining, remove any nails and other foreign bodies from
the workpiece.
Use a push block when working the ends of narrow stock.
Always store the push stick or the push wood handle with the
machine, also when not in use.
Specifications regarding the maximum or minimum size of the
workpiece must be observed.
Do not remove chips and workpiece parts until the machine is at a
complete standstill.
Never operate with the guards not in place – serious risk of injury!
Do not stand on the machine.
Connection and repair work on the electrical installation may be
carried out by a qualified electrician only.
Have a damaged or worn cord replaced immediately.
Make all machine adjustments or maintenance with the machine
unplugged from the power source.
Remove defective sawblades immediately.

3.3 Remaining hazards

When using the machine according to regulations some remaining
hazards may still exist
The moving sawblade in the work area can cause injury.
Broken saw blades can cause injuries.
Thrown workpieces can lead to injury
Wood chips and sawdust can be health hazards. Be sure to wear
personal protection gear such as safety goggles ear- and dust
protection.
Use a suitable dust exhaust system.
The use of incorrect mains supply or a damaged power cord can
lead to injuries caused by electricity.

4. Machine specifications

4.1 Machine Description

Fig 1