Publicité
•
Select the required number of springs based on the size of the plates. Unnecessary springs
are disconnected at the base of the machine.
•
Adjust the balance so that the plate (the part of the machine) is evenly supported on three
sides.
•
Before connecting to the power supply, check that the switch is in the "OFF" position.
•
Connect the power.
4. CLEANING AND MAINTENANCE
•
Prior to maintenance, make sure the unit is disconnected from the power supply mains.
•
Do not use wet wipes and aggressive cleaning agents to clean the surface and the heating
cylinder.
•
It is forbidden to spray cleaning products from aerosol sprays or pressure balloons on the
machine.
•
It is forbidden to wash electrical components with water.
5. SAFETY
•
Attention! Installation, commissioning and maintenance shall be performed by duly qual-
ified and licensed technical personnel as required by the regulations of the country where
this equipment is used.
•
Make sure that the mains voltage corresponds to the operating voltage of the machine,
check the installation of protection devices, and make sure that they conform to the re-
spective power and characteristics ratings.
•
The electrical wiring shall conform to the rated power of the machine. Non-conformity
may result in fire.
•
Before washing, repairing or moving the machine, first unplug it from the wall socket.
•
Perform maintenance or repair only after the machine has been disconnected from the
power supply.
•
In the event of any abnormal situations, users should immediately pull the plug out of the
socket and contact a service technician for repair.
All manuals and user guides at all-guides.com
EN
3
Publicité
