Publicité
Source language: German
Explication of warning symbols
Safety instructions
Product information
Application instructions
Unpacking
Spare parts list
Maintenance and cleaning
Technical Data
Warranty
Explication of warning symbols
Indicates an (extreme) hazardous situation, which, if
DANGER
not avoided, will result in death, serious injury.
Indicates a hazardous situation, which, if not avoid-
WARNING
ed, can result in death, serious injury.
Indicates a potentially hazardous situation, which, if
CAUTION
not avoided, can result in injury.
Indicates practices which, if not avoided, can result in
NOTICE
equipment damage.
Burns hazard!
CAUTION
Safety instructions
• Read the operating instructions in full before starting up and
follow the safety instructions.
• Keep the operating instructions in a place where they can be accessed by
everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and safety
and accident prevention regulations.
The dispersion tool may heats up during operation. In
CAUTION
particular in the processing of hot medium, the tool
must be cooled before it can be removed from the drive.
When in operation the dispersion tool can become
NOTICE
hot. If the dispersion tool is not inserted into the drive
flange correctly or the medium is hot, it can become extremely hot.
Don't touch rotating parts during operation.
WARNING
Wear your personal protective equipment in accor-
CAUTION
dance with the hazard category of the medium to
be processed. Otherwise there is a risk of splashing and evaporation of
liquids; body parts, hair, clothing and jewelry getting caught.
• The work has to be interrupted immediately if you notice unusual noise
and/ or increasing emission of liquid from the upper, sidewise rinsing
drilling. The bearings must be controlled, and replaced if necessary.
• Note the operating instructions of the disperser unit.
• Abrasion of the dispersion equipment or the rotating accessories can
get into the medium you are working on.
• Do not use any damaged dispersion tools e.g. with hairline cracks or splits.
Never run the dispersion tool dry. Without cooling by
NOTICE
the medium the bearing will be destroyed.
• The dispersion tool is not suitable for continuous operation. Likewise the
optimal dispersion duration and rotating frequency must be determined
by attempts. Usually a few seconds are sufficient, maximum duration is
one minute. Longer application times bring no improvements, increase
however the sample temperature substantially.
Content
EN
Page
7
7
8
8
8
8
9
10
10
7
Publicité
