Allmand NIGHT-LITE NL5000 Manuel D'utilisation page 16

Ground Surface
WARNING
Rollover Hazard
Positioning the light tower trailer on soft, unstable or
unlevel ground could cause trailer rollover, resulting in
death or serious injury. Always position the trailer on a
firm, level and stable surface and deploy the outriggers
before raising the light tower.
• Do not set up the light tower trailer on an incline of more
than 2.8° (5% grade) front-to-back and side-to-side.
• Do not position or set up the light tower trailer on unlevel
or unstable ground. Set up on smooth, flat and solid
ground surfaces only.
Wind
WARNING
Rollover Hazard
• Operating with the light tower raised in winds exceed-
ing 53 mph (85 km/h) can cause trailer tip-over result-
ing in death or serious injury. Do not operate with
the light tower raised in winds exceeding 53 mph (85
km/h).
When the light tower is in the operating position it is located
in the middle of a three-point outrigger system for optimum
balance and stability. This system was engineered to allow
the light tower to remain operational in sustained winds of 53
mph (85 km/h) with the light tower extended to full height and
the outriggers in position on a firm, level surface.
Leveling and Stabilizing the Light Tower Trailer
WARNING
Rollover Hazard
Positioning the light tower trailer on soft, unstable or
unlevel ground could cause trailer rollover, resulting in
death or serious injury. Always position the trailer on a
firm, level and stable surface and deploy the outriggers
before raising the light tower.
1. Position the light tower trailer on an adequate work site.
See Work Site Safety Considerations.
2. Block each wheel on each side with a suitable wheel
chock (A, Figure 11).
16
Figure 11
3. Level the light tower trailer using the tongue jack. See
Operating the Tongue Jack in the Transporting sec-
tion.
4. Deploy the outriggers:
a. Lift the outrigger locking pin (A, Figure 12).
b. Slide the outrigger (B, Figure 12) out until the pin
locks the outrigger in the operating position.
c. Pull the stabilizer jack locking pin (C, Figure 12)
securing the stabilizer jack in the transport position,
and rotate the jack into the operating position (D).
Make sure the pin locks the stabilizer jack in place.
d. Unfold the handle (E, Figure 12) of the stabilizer jack,
then turn clockwise to lower the jack until the jack foot
is firmly planted on the work site surface.
e. Repeat for the opposite outrigger and stabilizer jack.
f. Level the light tower trailer front to back and side to
side using the jacks.
5. To retract the outriggers:
a. Fully raise the stabilizer jack by turning the jack han-
dle counterclockwise.
b. Fold the handle.
c. Pull the locking pin securing the stabilizer jack in the
operating position, and rotate the jack into the trans-
port position. Make sure the pin locks the stabilizer
jack in place.
d. Lift the outrigger locking pin, and slide the outrigger in
until the pin locks the outrigger in the transport posi-
tion.
e. Repeat for the opposite stabilizer jack and outrigger.
WARNING
Rollover Hazard
Failure to deploy the outriggers before raising the light
tower could cause the light tower trailer to tip over, result-
ing in death or serious injury. Always deploy the outrig-
gers before raising the light tower.
A
www.allmand.com