Before You Call; Solutions To Common Problems - Kenmore PRO 790.33693 Manuel D'utilisation Et D'entretien

Table de cuisson à gaz;
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before You Call

Solutions to Common Problems

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
OCCURRENCE
Surface burners do not light
Surface burner fl ame burns half way
around.
Surface burner fl ame is orange.
POSSIBLE CAUSE/SOLUTION
Surface Control knob has not been completely turned to LITE. Push in and turn
the Surface Control knob to LITE until burner ignites and then turn control to
desired fl ame size.
Be sure gas supply valve is open.
Gas-air mixture needs a straight line to travel. Be sure burner is properly seated
in its support (models with open burners only).
Burner ports or slots are clogged. With the burner off , use a small-gauge wire
or needle to clean ports or slots.
Power cord is disconnected from outlet (electric ignition models). Be sure cord
is plugged securely into outlet.
Electrical power outage (electric ignition models). Burners can be lit manually.
See Setting Surface Controls in this Use & Care Guide.
Burner ports or slots are clogged. With the burner off , clean ports with a small-
gauge wire or needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the fl ame and allow burner to
operate until fl ame is full. To avoid this occurrence dry the burners thoroughly
following instructions under General Care & Cleaning.
Dust particles in main line. Allow the burner to operate a few minutes until fl ame
turns blue.
In coastal areas, a slightly orange fl ame is unavoidable due to salt air.
12

Publicité

Table des Matières
loading

Produits Connexes pour Kenmore PRO 790.33693

Ce manuel est également adapté pour:

790.34423

Table des Matières