Parkside PAT 12 B2 Instructions D'utilisation Et Consignes De Sécurité page 42

˜ Setting the impact force
NOTE
Select the lowest impact force that
u
is su cient for fastening works to
avoid over driving or damaging the
materials to be fastened.
Increasing the impacting force:
o
Turn the impact force control
a clockwise direction (towards the
+ marking).
Decreasing the impacting force:
o
Turn the impact force control
anti-clockwise direction (towards the
– marking).
If the impact force is set correctly,
o
the crown of the staple or head
of the nail is ush with the
fastened material.
˜ Clearing jammed staples/
nails
WARNING!
m
If a staple or nail is jammed, do
u
not pull the trigger
nails may otherwise be triggered
accidentally by the product after
removing the staples or nails.
1. Open the magazine
push rod
2. Remove the jammed staples/nails
from the magazine
˜ Checking the battery level
(Fig. G)
Press down the safety contact
o
onto a hard surface. The remaining
in
energy level is shown on the LEDs of
1 ] [
the battery level indicator
LEDs
in a
[ 1 ]
Red
Red and orange
Red, orange and
green
NOTE
When the battery level is below
u
30
3 ] [
Remove the battery pack
from the product before
clearing the jammed staples or
nails.
[ 8 ]
from the product.
9 ] [
.
[ 8 ]
Battery level
below 30 %
30–70 %
above 70 %
Charge the battery pack
! Staples or
5 ] [
by pulling the
[ ]
.
2 ] [
.
5 ] [
GB/IE 39