Mounting - Atag WO6111BM Notice D'utilisation

INSTALLATION

Mounting

A
B
A
C
A
D
A
A
A
EN 14
Against the wall
1. Remove the filters from the extractor hood.
2. Hold the hood against the wall.
3. Working through the hood, draw the mounting holes (A) and the
hole to secure the hood (B).
4. Drill the holes.
5. Push the wall plugs supplied into the holes.
6. Insert the screws into the 2 mounting holes (A).
NB: screw the screws in until 1 cm is left protruding from the wall.
7. Hang the hood on the 2 mounting screws.
8. Tighten the mounting screws.
9. Tighten the locking screw.
10. Connect the flue pipe to the flue ring.
Below a kitchen cupboard
1. Working through the hood, draw the 4 mounting holes (A), the hole
for the power lead (C) and the hole for the flue (D) on the bottom of
the kitchen cupboard.
2. Drill the holes.
3. Pull the power lead upwards through the hole provided and push
the flue ring through the opening.
4. Hang the hood, through the bottom of the kitchen cupboard, on the
4 mounting screws. Tighten the screws.
5. Connect the flue pipe to the flue ring.