Parts And Operating Controls; Before Using For The First Time; Boiling Water - Bosch TWK740 Série Mode D'emploi

en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you
a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid
3 Lid opening button
4 On/Off switch, illuminated
5 Limescale filter (removable)
6 Base
7 Cable tidy
Important: Use the kettle 1 only with its
included base 6.
■ Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1 without water and do not overfill it;
observe the min and max markings.
If the kettle is too full, the water will boil
over!
Before using
for the first time
■ Remove any stickers or film.
■ Unroll the right amount of cable from the
cable tidy 7 and plug it in.
■ Fill the kettle 1 with water. Bring the
water to a boil and discard it. Repeat the
procedure. This will make sure that the
kettle is clean for normal use.
■ When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
8

Boiling water

■ Fill the kettle 1 with fresh water, either
through the spout or by pressing the
opening button 3 to open the lid 2.
■ Read the quantity on the water level
indicator. Do not fill with less than
0.3 litres or more than 1.7 litres of water!
■ Close the lid 2.
■ Press down the switch 4; the switch
lights up. The water is heated.
■ The kettle switches off automatically
once the water has boiled.
The appliance can also be switched off at
any time by pulling up the switch 4.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.: Only operate the kettle with the lid 2
closed and the limescale filter 5 inserted,
otherwise the kettle will not switch off.
For physical reasons, the base 6 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.