Using The Remote Control - Muskoka Gold MFB33WSC Guide D'utilisation Et D'entretien

Lift and gently remove the log rack to reveal the light bulbs.
6.
Unscrew each light bulb and replace with a new one.
7.
Reverse steps 3-7 to re-assemble the firebox.
8.
OPERATING INSTRUCTIONS
The firebox main power "on/off" switch (see Fig. 4) must be switched
"on" before any of the control functions, (on the firebox and/or remote control) will operate. NOTE: The
main switch does not have to be turned off when the firebox is not being used for brief time periods. If
however, you are not planning to use your firebox for extended time periods or going away on vacation,
we recommend the main power "on/off" be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control.
This feature allows you to operate the unit in 2 different ways;
• As a full featured fireplace insert with both flame effect and heater operating simultaneously.
• As a visual effect with flame effect only. (i.e. no heating cycle)
This firebox insert is not designed to operate in "heat" only mode without a flame effect.
NOTE:
All of the firebox control functions can be accessed in 2 ways:
Fig. 3
Fig. 4
4
1
2
4
3
3 2 1

1. Using the remote control:

Press the "main power button" on
1. Main Power Button:
the firebox, the flame effect (only) will turn on. To turn the
firebox "off" press the "main power button" again.
Press the flame button to achieve
2. Flame Effect:
the desired effect. You can go up 4 steps after
flame shuts off (no heat)
"Press the heat button once for "ultra-high"
3. Heat:
heat setting; twice for "high" heat setting;
three times for "medium" heat setting and a
fourth time for "low" setting" (
effect is always on when the heat cycle is
operational) Pressing the button a "fifth" time turns
the heater off.
This light illuminates the brick
4. Down Light button:
refractor and can act as a night light.
2. Using the manual controls located on
the firebox behind the upper front
access panel.
1. Main Power Button:
on the firebox, the flame effect (only) will turn on.
To turn the firebox "off" press the "main power
button" again.
Press the flame button to achieve the
2. Flame Effect:
desired effect. (no heat)
(See details above under Remote Control)
3. Heat:
4. Down Light Button:
refractor and can act as a night light.
4
the flame
NOTE:
Press the "main power button"
This light illuminates the brick