SEVERIN KS 9760 Mode D'emploi page 19

Masquer les pouces Voir aussi pour KS 9760:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 So that the doors can close tightly against the frame, take the utmost care that they are properly
aligned during re-assembly.
Open the freezer door (18).
Remove the fixing screws (1 and 3) from
the top cover (two screws at the front and
two at the rear), and take off the cover
(4).
Unscrew the upper hinge bracket (5) and
remove it. Caution: the door must be
supported while this is done.
Take off the freezer door (18).
Unscrew the hinge pin (7) together with
the nut (6) and washers (8), and fit the
entire assembly to the opposite side of the
hinge bracket.
Undo the fixing screws (11) on the centre
hinge bracket (10).
Caution: Support the door.
Take off the centre hinge bracket (10)
together with the hinge pin washers and
the plastic plate (9).
Take off the refrigerator door (13).
Tilt the whole unit towards the rear.
Unscrew the lower hinge bracket (14)
and take it off.
Unscrew the hinge pin (15) from the
bracket, and re-insert it from the other
side.
Remove both screws on the left of the
underside and replace them on the right.
Fit the lower hinge bracket (14) on the
left of the underside.
Put the washers on the hinge pin.
Remove the cap (19) from the freezer
door and the cap (16) from the refrigerator door and replace them on the opposite side of the
doors.
Take off the caps (17) from the partition between the refrigerator and freezer compartments and
remove the screws.
Replace both screws on the opposite side and then the caps.
Fit the refrigerator door (13) onto the pin (15) of the lower hinge bracket.
Fit the pin of the centre hinge bracket (10), together with the washers, to the refrigerator door
(13).
Fit the centre hinge bracket (10) together with the plastic plate (9).
Remove both screws from the upper left and replace them on the right.
Place the freezer door (18) onto the pin of the centre hinge bracket.
Fit the pin of the upper hinge bracket (5) to the freezer door (18), and then fit and secure the
upper hinge bracket (5).
Note: If necessary, the alignment of the doors can be adjusted by slightly loosening the hinge bracket
19

Publicité

Table des Matières
loading

Table des Matières