Install Warming Drawer Deflector Kit (Only For Ovens Installed Above Warming Drawers) - Jennair JMW3430I Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Remove the tape from the black front trims and remove the
zip tie from the mounting spacer.
Securely fasten the oven to the cabinet using the
#8-14 x 1" (2.5 cm) screws provided.
Insert screws through the holes in the black trim aligning
with the holes in the oven frame and mounting spacers
already in place. Do not overtighten screws.
A
B
C
D
A. Oven frame
B. Mounting spacer
C. Oven frame hole
D. Black trim piece
5. The bottom vent is shipped in the foam packing at the top of
the oven. Install the bottom vent (C) as follows:
Align vent tab (B) with oven frame (A) as shown.
Using one #8-18 x 3/8" (9.5 mm) screw (D) on each side
of the vent tab (B), fasten the vent securely to the oven.
D
A. Oven frame
B. Vent tab
8
B
A
B
C
C. Oven vent
D. #8-18 x 3/8"
(9.5 mm) screws
6. Replace oven racks.
7. Replace the oven door. See the "Replace Oven Door(s)"
section.
8. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See
"Prepare Built-In Microwave/Oven Combination" section.
9. Reconnect power.
10. The display panel will light briefly, and "PF" should appear in
the display.
11. If the display panel does not light, please reference
the "Warranty."
Install Warming Drawer Deflector
Kit (Only for Ovens Installed
Above Warming Drawers)
On combo microwave/oven models installed above a warming
drawer, a warming drawer deflector kit must be installed.
See the "Tools and Parts" section for ordering information.
Parts Supplied
A. Phillips head screws (4)
only 2 screws for 27" (68.6 cm) size
B. Warming drawer deflector (1)
Install Deflector Kit
1. Align the deflector (B) with the vent (C) as shown.
2. Using two #8-18 x 1/4" (6.4 mm) screws (A) on each side of
the deflector (B), fasten the deflector securely to the vent.
NOTE: On 27" (68.6 cm) models, only one #8-18 x 1/4"
(6.4 mm) screw is used on each side.
A
A. #8-18 x 1/4" (6.4 mm) screws
B. Warming drawer deflector
C. Vent
3. Align vent tab (B) with oven frame (A) as shown.
A
B
B
C
B
C

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Jmw3430il02Jmw2427il02

Table des Matières