Charging The Li-Ion Battery; Install Battery On Car - Hobbytech REVOLT BX-10 3.0 Notice D'utilisation

EVEN IF THIS CAR IS A READY TO RUN KIT, YOU STILL HAVE SOME LITTLE THINGS TO DO TO FAMILIARIzE WITH YOUR
PRODUCT.
PLEASE FOLLOW THESE STEPS.
bodY and winG assEmblY
A
A Remove the body clips.
B Remove the body.
C
Remove the body mask before putting the stickers.
Put the stickers.
Fix the wing on the its mount with the o-ring and body clips
provided with the kit.
antEnna pipE & wirE assEmblY
Slide the antenna wire into the antenna pipe carefully.

cHarGinG tHE li-ion battErY

WARNING!
Do not use the charger if wire is
frayed or worn.
Do not use the charger near
water or worm.
Connect the AC charger to
a wall 220V plug, the green
LED brights. Then connect the
battery, the LED becomes red :
battery is charging.
After a charging time of 2 hours,
the battery will be charged. (red
LED becomes green).
6 6
B
C
Fix the antenna pipe into its holder.
Tighten the small screw provided to secure the antenna tube.

install battErY on car

Put the battery in its mount.