M-Audio Axiom AIR 25 Manuel D'utilisation page 12

Other Controls
Directional Buttons
The Directional buttons can be used to control certain supported software features. Press the
HyperControl button next to the Directional buttons to enable this function.
Trigger Pads
The trigger pads can be used to trigger drum or instrument sounds mapped by your software, but they
have additional functions in HyperControl Mode (depending on your software's specific
implementation of HyperControl). Press the HyperControl button next to the trigger pads to enable
this function.
Identifying Control Assignments
Whether you're in HyperControl Mode or using your own control assignments, it can be helpful to see
which hardware control is assigned to which software parameter.
To check the control assignment of a hardware control:
1. Press and hold the Identify button, or double-press it to "latch" it on. All control output from
Axiom AIR will be temporarily halted, and the button will flash red.
2. Manipulate the control you want to identify. The assigned parameter and its current setting will
appear on the LCD.
3. To go back to normal operation, release the Identify button or, if you latched it, press it once
again.
Controlling Ignite
Ignite, included with your Axiom AIR, is a creative tool designed for rapid and fluid capture,
refinement, and sharing of musical ideas. You can use it on its own or as a counterpart to your
favorite DAW.
To download Ignite, visit airmusictech.com/getignite.
For more in-depth information on Ignite, please see the Ignite documentation.
Axiom AIR keyboards come pre-configured to control Ignite through HyperControl. When you launch
Ignite with your Axiom AIR connected to the computer, you can use Axiom AIR's controls in the
following ways:
Transport Controls
Press the HyperControl Mix Mode button (
transport buttons to control those transport functions in Ignite.
Navigation
Use the Directional buttons to navigate through Ignite's tabs and sub-menus, depending on the
current control focus.
Instruments
Refer to your Ignite's HyperControl user guide (at m-audio.com/hypercontrol) to see which
parameter is assigned to each control.
button) on the main control panel, and then use the
12