Metabo PA 14.4-18 LED-USB Notice D'utilisation page 11

start the power supply pressing (for at least
0,5 seconds) the on/off switch (6). The power
indicator (7) will light up green.
Only connect USB devices which are
compatible with the USB standard. Using
incompatible devices can lead to malfunctions,
damage or injury.
Disconnect the USB device after use or after
charging from the Power Adapter.
After a period of 7 hours, the Power Adapter will
switch off automatically.
6.3 12V connector for operation of the heated
jacket HJA 14.4-18 (6.570...)
Connect the heated jacket HJA 14.4-18 using the
corresponding cable to the Power Adapter by
plugging in the 12V connector (5) and start the power
supply by pressing (for at least 0,5 seconds) the on/
off switch (6).
Separate the heated jacket after use from the
Power Adapter.
After a period of 7 hours, the Power Adapter will
switch off automatically.
12V connector is only intended for use with the
Metabo heated jacket HJA 14.4-18.
6.4 Removal of the battery pack (8)
Hold the battery pack (8) with both hands at the body
and press hard with both thumbs against the cover
glass ofthe LED lamp (1). Push the Power Adapter
axially towards the back away from the battery
pack.The tight fit of the battery pack is required to
avoid unintentional removal/falling off when using the
heated jacket.
7. Faults
A connected load that is too high at the outputs
(permanently greater than 16.8W) can lead to
overheating of the Power Adapter. The overload
safety device temporarily then reduces the output
current.
In order to prevent overloads, check the combination
of the connecting devices so that the connected
continuous output adds up to less than 16.8W.
Typical values are:
Metabo Heated jacket HJA 14.4-18 (max. heating capacity
16,2 W)
Heating element front
Heating element rear
Smartphone
Stage flashing red
Stage red
Stage orange
Stage blue
Stage flashing red
Stage red
Stage orange
Stage blue
2.5 - 7.5 W (5V DC: 0.5 - 1.5 A)
11
5.4 W
4.0 W
2.7 W
1.4 W
10.8 W
8.0 W
5.4 W
2.8 W