Publicité
AUDIBLE SIGNALS
DURING OVEN SETTINGS
SETTING THE CLOCK
The CLOCK and the "0" button are combined to one single
button. The clock function is a 12-hour system. To set the
clock follow the steps below:
1. While in stand-by mode, press "0 / Clock"
2. button for approximately 3 seconds.
3. Using the number pads enter the correct time. (The
digital clock will allow a setting of 1:00 to 12:59). You
must press at least 3 numbers (1 for hour and two for
minutes)
4. Once the desired time is entered, press
the START / +30 Sec to confirm the setting and exit the
clock setting mode.
NOTE: When a setting is less than four numbers (0:00),
press START/+30 SEC to confirm the setting. You don't
need to press START/+30 SEC pad when a setting is
4 numbers(00:00), cause the setting of 4 numbers is
confirmed and exited the clock setting mode directly.
You can check the clock time while cooking is in progress
by touching the CLOCK pad.
EXPRESS COOK: Use the EXPRESS COOK
buttons (1 – 6) for quick start pre-timed cooking.
Number Pad
1
2
3
4
5
6
ADD 30 SECONDS: Touch this button for quick 30
second cook time. Pressing this button during a set
cook cycle will add 30 seconds to the current time.
Every time the button is pressed an additional 30
seconds will be added to the current cook time.
NOTE: During the EXPRESS COOK, AND TIME
DEFROST, you can add 30 seconds each time the
button is pressed.
HOW TO SET THE OVEN CONTROLS
SETTING A COOKING PROGRAM
Cook Time
1 Minute
2 Minutes
3 Minutes
4 Minutes
5 Minutes
6 Minutes
ONE SIGNAL: Oven accepts the entry.
TWO SIGNALS: Oven does not accept the
entry, check and try again.
SETTING THE KITCHEN TIMER
1. Touch TIMER.
2. Enter the desired amount of time by
touching the number pads. Time is in
minutes and seconds and set from
left to right.
3. Display will show the desired setting:
(00:05 for 5 seconds / 24:05 for 24
minutes and 5 seconds)
4. Touch Start / +30 Sec to start the
countdown.
Note: Time countdown can be seen in
display for 5 seconds before clock or
cooking time is returned to display.
Touch timer button and then STOP /
CANCEL to cancel the timer during the
countdown process.
A. One-stage Cooking
Touch the POWER pad to select
the power level, the settings will
cycle according to the table
shown.
1. Use the number pads to set
a cooking time. You can set
a cooking time from one
second to 99 minutes and
99 seconds.
2. Press the START/+30 Sec button
to start the cooking process.
English - 9
Power
Cooking
Pad
Power
HIGH
100%
M. HIGH
80%
MED
50%
M. LOW
30%
LOW
10%
Publicité
