Publicité
Auto tuning
1. Set the unit to FM mode.
2. Press the auto scan button (18) once; the unit will start to scan upwards until a radio station is
received. Press tuning down button (11) once and then press the auto scan button (18), the unit will
scan downwards. If the radio data system (RDS) broadcasting signal is received, the unit will set the
actual time automatically.
3. Adjust volume knob (14) for the desired volume level
FM scan setting
After auto tuning if too many unwanted weak radio stations are received, you can select strong stations
only by filtering out the weaker signals.
1. In FM mode, press "Menu/Mem/clk‐adj" button (12) to enter the "Menu", then press Skip down
(11) or Skip up
(19) button to select "Scan setting".
2. Press "Stop/Enter" button (10) to enter the "Scan setting", then press Skip down
(19) button to select "Strong station only". Then press "Stop/Enter" button (10) to confirm the
setting.
3. Perform the auto tuning operation again as above.
FM & FM‐stereo reception
The unit will default to the FM mode in Mono. Thus, if FM stereo signal received, set the FM mode to
Stereo by press Menu button (12), then press Skip down
Audio setting, press Enter button (10) and press Skip down
select FM stereo, then press Enter button (10) to confirm. When stereo signals are weak and noisy. It
is preferable to change the FM mode by the same procedure.
Hints for best reception: ‐
FM: the receiver has a rod antenna (6) at the rear cabinet. It should be totally extended for the best
reception.
Radio data system (RDS)
This is the feature which displays the information released from the radio broadcast and will showed on
the LCD display step by step as below by pressing the Play mode/info button (21) continuously.
Radio text program type frequency mono/stereo time date
Digital audio broadcasting (DAB) radio
1. Set the unit to DAB mode by press Function button (9).
2. Press the Play/pause
Press Skip down
"Stop/Enter" button (10) to confirm the selected channel.
3. Press the Play mode/info button (21) continuously to check the below info released by DAB.
Signal strength program type Group name frequency signal error transfer rate time
date
4. Adjust volume knob (14) for the desired volume level.
Dynamic range control
This apparatus provides three dynamic range modes to match different program types in DAB mode.
1. In DAB mode, press "Menu/Mem/clk‐adj" button (12) to enter the "Menu", then press Skip down
(11) or Skip up
(19) button to select "DRC".
2. Press "Stop/Enter" button (10) to enter the "DRC" setting, then press Skip down
(19) button to select "DRC high/low/off" mode. Then press "Stop/Enter" button (10) to confirm
the setting.
3. In any state press "Menu/Mem/clk‐adj" button (12) to quit the setting mode
/Scan button (18) once; the unit will start a full scan from range 11b‐12d.
(11) or Skip up
(19) button to select your desired DAB channel then press
(11) or Skip up
(11) or Skip up
7
(11) or Skip up
(19) button to select
(19) again to
(11) or Skip up
Publicité
