Publicité
SERIAL CABLE INSTALLATION
The supplied serial cable must be installed when
the TV 301SF Navigator or the optional vent valve
have to be controlled by means of a remote com-
puter.
The cable is installed fixing the 9 pin D-type con-
nector into the P2 serial connector as shown in the
following figure.
TV 301SF CONTROLLER INSTALLATION
The controller can be mounted in two position:
−
bottom mounting (as per the complete system)
−
side mounting.
To install the controller execute the following pro-
cedures.
Bottom mounting
See the following figure.
1. Turn the pump upside-down;
2. Screw the 4 fixing studs (provided with the ac-
cessories bag) in the holes on the bottom of
pump;
3. Place the controller on the studs aligning the 4
rubber holes on the top of the controller case;
4. Press the controller towards the pump;
5. Turn the pump again;
6. Plug the line cord and connect the pump cable
to the pump;
7. Connect the mating connector with the jumper
on the interlock signal to start the pump.
MOUNTING 1
Side mounting
The L-shaped bracket (P/N 969-9970) is available
as an option.
See the following figure.
1. Screw the 4 fixing studs (provided with the ac-
cessories bag) in the holes on the L-shaped
bracket;
86/89
TECHNICAL INFORMATION
NOTE
87-900-957-01(F)
Publicité
