Bosch 300 Serie Instructions D'installation page 8

en-us Installation Procedure
Use a level on the top front to see that both feet are
3.
even.
4.2 Attach Power Cord
Plug the end of the supply cord into the back of the
▶
dishwasher.
Be sure to push it all the way in until fully seated.
‒
The outlet for the power supply cord should be located
in a cabinet or wall adjacent to the dishwasher cabinet.
Do not plug dishwasher into the wall outlet until all the
steps of the installation are complete.
Notes
¡ If you require a permanent wiring connection, order kit
junction box accessory kit SMZPCJB1UC.
¡ If local electrical codes require clips to secure the power
cord wire to the dishwasher, use accessory kit
SMZEPCC1UC.
4.3 Mounting Brackets
Before installing the supplied mounting brackets, decide
which method of securing the dishwasher into its
enclosure will be used, top (wood or porous material) or
side (stone or solid surface). Once the mounting brackets
are installed on the dishwasher, removing them is difficult
and will damage the mounting brackets and the
8
dishwasher. If you have a Fully Integrated Panel, do not
attach mounting brackets until after attaching the panel to
the door.
WARNING
Avoid tip over hazard
Do not use the dishwasher until it is completely
▶
installed. When opening the door on an uninstalled
dishwasher, carefully open the door while supporting
the rear of the unit. Failure to follow this warning can
result in serious injury.
Top Mount
Top Mount is used for counter tops made of wood or other
materials that can be easily drilled, or for openings wider
than 18".
Orient the mounting brackets and position the tabs into
▶
openings on the dishwasher's front corners.
Side Mount Force Distributor
The side mount force distributors are used for counter tops
made of marble, granite, or other solid surface material
that cannot be easily drilled. Also, it is for openings that
are 18".
Insert a side mount force distributor into the opening in
▶
each side.