Bosch 300 Serie Instructions D'installation page 7

If the dishwasher is to be installed in a corner, ensure that
there is adequate clearance to open the door as shown.
3 Installation Preparation
Installation Preparation
After locating the proper place for your dishwasher, create
Installation Preparation
an opening to allow for water, drain and electrical lines on
the appropriate side.
Cut a rectangular hole 2.5" x 3.5" in the rear corner on
1.
the sink facing side.
If the opening is made through wood, sand it smooth.
If the opening is made through metal, use the Edge
Protector with Power Cord clips Kit SMZEPCC1UC.
Remove the hose clip from the back of the dishwasher.
2.
It can be used later to hold the drain hose inside your
cabinet.
4 Installation Procedure
Installation Procedure
Follow these instructions to install the dishwasher.
Installation Procedure
4.1 Pre-level the Dishwasher
Set the dishwasher to the correct height before it goes into
the cabinet.
Measure the height of the cabinet opening.
1.
Raise the front of the dishwasher to approximately 1/2"
2.
lower than the height of the opening by turning the feet
clockwise.
or
You can raise the rear foot after the unit is in the cabinet
opening.
Installation Preparation en-us
7