Bosch 300 Serie Instructions D'installation page 11

4.7 Secure the Dishwasher
Open the door carefully.
1.
Hold the dishwasher in place with one hand while
opening the door with the other hand.
For top mount, drive the mounting screws through the
2.
holes in the mounting brackets into the countertop.
For side mount, first remove the cutlery drawer.
3.
Remove the caps from inside the dishwasher.
4.
Drive screws into the openings.
5.
1 Depending on the appliance specifications
Snap the caps back into place making sure they are flat.
6.
Reinsert the cutlery drawer.
7.
4.8 Attach the 2-part Toe Panel
Place the slotted toe panel on the dishwasher.
1.
It should rest on the floor.
‒
Position the mating front toe panel on top of the rear toe
1 2.
panel with the angled edge on the mating edge of the
dishwasher.
To secure the toe panels, drive the two black torx
3.
screws through the holes in the toe panel and the
dishwasher base.
To avoid damaging the dishwasher, use the supplied
‒
screws.
5 Dishwasher Connection Dishwasher Connection
Follow these instructions to connect the dishwasher.
Dishwasher Connection
5.1 Installing the Water Inlet Connection
The hot water heater should be set to deliver
approximately 120 °F (49 °C) [max. 140 °F/ (60 °C)]
water to the dishwasher. Water that is too hot can cause
Dishwasher Connection en-us
1
11