Publicité
ENGLISH
Repeat the process until the resulting liquid is as clear as possible.
5.
6.
When finished, repeat the process again using only water in the container until all traces
of detergent have been removed from the inside of the cappuccinatore and the ducts.
7.
Reassemble the entire tank and enjoy your frothed coffee.
Manual cleaning
1.
Remove the cappuccinatore from the appliance. To do so, you will have to press both
release tabs on the sides and pull downwards.
2.
You will notice that the cappuccinatore is composed of three parts: a small hard plastic
frame, a steam knob, and a rubber part in which the steam knob is placed. You can
separate the rubber part from the frame by pulling outwards. Do this.
Once you have these two parts separated, pull the steam knob outwards to remove it.
3.
4.
With the three parts separated and differentiated, use the metal cleaning accessory to
insert it into as many holes as possible and manually descale the solidified milk residues.
In addition, use detergent and plenty of water to get all three parts clean inside and out.
5.
When finished, reassemble the three parts in reverse order of disassembly.
NOTE: also, make sure to clean the tube that connects the milk tank to the cappuccinatore.
There may be solidified milk residues.
5. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If a mechanical failure occurs in the appliance, please contact the official Cecotec Technical
Support Service. If the problem persists, contact only authorised technicians, the distributor,
or the dealer.
50
CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
Number
Problem
Num
1.1
1
The control panel
display shows the
water tank indicator
1.2
light
The display shows
2.1
2
a square of dashed
lines (Fig. 5), and the
appliance does not
dispense water
2.2
2.3
The display shows
a square of dashed
3.1
3
lines (Fig. 5), press
the Exit icon and the
water will exit, but
the warning cannot
be removed
CREMMAET COMPACTCCINO BLACK / BLACK ROSE / WHITE ROSE / BLACK SILVER
ENGLISH
Possible cause
Solution
Fill the water tank and insert
Water tank is out of
it into the appliance.
water.
When the appliance is in
It is necessary to
standby mode:
calibrate the water level
1.
Remove the water tank.
sensor.
2.
Remove the sticker from
the reset button on
the water level sensor
located on the corner of
the tank housing. Then,
press and hold the reset
button for 6 seconds.
3.
Unplug the appliance.
Plug in and switch on
4.
the appliance after 10
seconds. Insert the tank
when you have filled it.
The water tank is not
Install the tank properly
correctly installed.
inside the coffee machine.
Push the bottom side all the
way in.
No water flows through
Open the rear panel and
the pump.
inject water into the water
pump.
The internal piping is
Please contact the official
blocked.
Cecotec Technical Support
Service.
Please contact the official
Water flow meter wires
Cecotec Technical Support
are coming loose
Service.
or the water flow meter
is broken.
51
Publicité
